Yamaha RX Z9 MCXSP10 Manual - Page 106

ZONE 2 3 Press an input selector button to select the input source you want to listen to in the second room. The display window shows "2: name of selected input". V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD Note Signals input to V-AUX and PHONO jacks cannot be sent to Zone 2. 4 You can control this unit from Zone 2 using the input selector, STANDBY, SYSTEM POWER, MUTE and VOLUME +/- buttons. MACRO TRANSMIT RE-NAME CLEAR LEARN MACRO OFF ON SYSTEM POWER STANDBY V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD PURE DIRECT TITLE MULTI CH IN SOURCE INPUT MODE DISPLAY TOP MENU SELECT SEARCH ENTER EXIT SOUND - CHAPTER + POWER REC STOP PAUSE PLAY 10KEY AMP STEREO HALL CHURCH JAZZ 10KEY AMP STEREO 1 HALL 1 2 JAZZ 5 ROCK 6 6.1/5.1 CHP/INDEX MOVIE 9 THX 0 A/B/C/D/E PRESET HALL 2 3 CHURCH 4 MUSIC ENTERTAIN 7 8 /DTS +10 NIGHT +100 TV INPUT TV VOL CH TV MUTE MUTE STRAIGHT VOLUME DISC EFFECT PUSH * * VOLUME +/- can only be used when Variable is selected in Zone 2 Volume (see page 85). Further, you cannot adjust the volume of signals output from ZONE 2 COAXIAL OUT. 5 Press SOURCE SELECT k/n to exit from the Zone 2 mode. Notes • The source in Zone 2 and the source available for recording are always the same. • "Zone 2" appears in the display window only when k is pressed, and SYSTEM only when n is pressed. ■ Turning this unit to either on or standby SYSTEM POWER and STANDBY work differently depending on the selected mode that appears on the display window. • When the Normal or Zone2 mode is selected, you can turn the main unit or Zone 2 to on/standby individually. • When the System mode is selected, or when YPC is selected as the amplifier library (L:AMP) code, you can turn the main unit and Zone 2 to on/standby simultaneously. LCD display SYSTEM POWER/ STANDBY Normal mode* Name of component Turns the main unit to on/standby Zone 2 mode "Zone 2" or "2:name Turns Zone 2 to on/ of component" standby SYSTEM mode "SYSTM" Turns everything (the main unit and Zone 2) to on/standby * "MAIN" appears for a few seconds when SYSTEM POWER or STANDBY is pressed. ■ Special considerations for DTS software The DTS signal is a digital bitstream. If you attempt to send the DTS signal to the second room you will only hear digital noise (that may damage your speakers). Thus, the following considerations and adjustments need to be made when playing DTS encoded discs. For LDs or DVDs encoded with DTS Only 2 channel analog audio signals may be sent to the second/third room. • for LDs: Set your LD player's left and right outputs to the analog soundtrack. • for DVDs: Use the disc menu to set the DVD player's mixed 2-channel left and right audio outputs to the PCM or Dolby Digital soundtrack. For CDs encoded in DTS To avoid unexpected noise, DO NOT USE the Zone 2 feature with CDs encoded in DTS. 102