Yamaha RX Z9 MCXSP10 Manual - Page 93
Programming codes from other remote controls, Set 10KEY/AMP to 10KEY. - avs
UPC - 027108918204
View all Yamaha RX Z9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
5 Press LEARN again to exit from the setup mode. LEARN REMOTE CONTROL FEATURES 3 Place this remote control about 5 to 10 cm away from the remote control for your component on a flat surface so that their infrared transmitters are aimed at each other. TRANSMIT RE-NAME CLEAR LEARN MACRO SYSTEM POWER CABLE DTV/LD VCR 1 SOURCE INPUT MODE Notes • The supplied remote control does not contain all possible manufacturer codes for commercially available AV components (including YAMAHA AV components). If operation is not possible with any of the manufacturer codes, program the new remote control function with the Learn feature (see below) or use the remote control supplied with the component. • If you have already programmed a remote control function for a button, the function by learning programming takes priority over the setup manufacturer code function. • "ERROR" appears in the display window if you press a button not indicated in the respective step, or when you press more than one button at the same time. Programming codes from other remote controls If you want to program functions not included in the basic operations covered by the manufacturer code, or an appropriate manufacturer code is not available, do the following. You can program any of the buttons available in the component control area (see page 87). The buttons can be programmed independently for each component. Note This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the remote control of your component.) 1 Set 10KEY/AMP to 10KEY. 10KEY AMP y It is also possible to program in this unit's control area with 10KEY/AMP set to AMP. However, if you do this, you will not be able to control this unit and select sound field programs. 2 Press an input selector button to select a source component. V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD EXIT TOP SOURCE INPUT MODE EXIT TOP ENTER ENTER PURE DIRECT TITLE MULTI CH IN PURE DIRECT TITLE MULTI CH IN DVD DVR VCR 2 DTV/LD VCR 1 DVD DVR VCR 2 CD SAT MD/TAPE CD-R CABLE CD SAT MD/TAPE CD-R V-AUX TUNER PHONO STANDBY SYSTEM POWER V-AUX TUNER PHONO STANDBY MACRO OFF ON TRANSMIT RE-NAME CLEAR LEARN MACRO MACRO OFF ON 5 to 10 cm (2 to 4 in.) 4 Press LEARN using a ballpoint pen or similar object. Do not press and hold LEARN. If you hold down LEARN for more than 3 seconds, the remote control enters the manufacturer code setting mode. LEARN Flashes alternately y Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press LEARN again. 5 Press the button for which you want to program the new function. "LEARN" is displayed. ADVANCED OPERATION English 89