Yamaha YSP-2500 Owners Manual - Page 66
Advanced setup list - firmware update
View all Yamaha YSP-2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Advanced setup list Menu TURN ON VOLUME MAX VOLUME INPUT LOCK PANEL LOCK IR INPUT POWER AC ON STANDBY MEMORY PROTECT YRB FL YRB FR YRB SL YRB SR AUTO POWER STANDBY FW UPDATE INITIALIZE Settings/Adjustable range OFF (Not set) (default), 1 to 70 1 to 99, MAX (Maximum) (default) ON (INPUT key operation is disabled) OFF (INPUT key operation is enabled) (default) ON (Key operation on the center unit is disabled) OFF (Key operation on the center unit is enabled) (default) ON (Enables power-on) OFF (Disables power-on) (default) ON (Enters standby mode) (default) OFF (Restores the state before power was lost) ON (Protect is performed) OFF (Protect is not performed) (default) YES (The reflection board is used) NO (The reflection board is not used) (default) YES (The reflection board is used) NO (The reflection board is not used) (default) YES (The reflection board is used) NO (The reflection board is not used) (default) YES (The reflection board is used) NO (The reflection board is not used) (default) ON (This unit turns off automatically) (default setting for U.K., Europe and Russia models) OFF (This unit does not turn off automatically) (default setting other than U.K., Europe and Russia models) 02.00.04 (The firmware version is displayed) START OK? (Firmware is updated) OK (All settings are restored to their default values) CANCEL (Settings are not restored to their default values) (default) Description Set the initial volume level when the power of this unit is turned on. When set to "OFF", volume level is the same as when this unit is turned off. Set the maximum volume level so that this unit will not output sound beyond the limited volume level. Select whether or not to enable the INPUT key on the center unit. Select whether or not to enable key operations on the center unit (except the advanced setup operations). Select whether or not to automatically turn on this unit by pressing an input selector key on the remote control when the unit is turned off. Set this unit's power to off when the AC power is recovered after the power to this unit was lost temporally (disconnect the AC power plug from the wall outlet, power outage, etc.). Protect the settings you have saved in the system memory. Use the YRB-100 sound reflection board for the front left channel. Refer to page 73 for details of YRB-100. Use the YRB-100 sound reflection board for the front right channel. Refer to page 73 for details of YRB-100. Use the YRB-100 sound reflection board for the surround left channel. Refer to page 73 for details of YRB-100. Use the YRB-100 sound reflection board for the surround right channel. Refer to page 73 for details of YRB-100. When set to "ON", this unit turns off automatically in any of the following situations: • Audio is coming from the selected input source. However, no operations have been performed for 8 hours or more. • Bluetooth is selected as the playback device. However, no audio has come out from the device or no operation has been performed for 20 minutes or more. • HDMI 1, 2, or 3 is selected as the playback device. However, the playback device has been disconnected from the selected HDMI IN jack for 20 minutes or more. Confirm firmware version/update firmware. Reset all of the parameters of this unit to the factory presets. When the unit freezed, the problem may solve by restoring to their default values. • Initializing this unit also initializes measurement results for IntelliBeam and settings stored in system memory. Perform "AUTO SETUP" from the "IntelliBeam" menu again. SETTINGS ➤ Advanced setup En 66