Yamaha YSP-2500 Owners Manual - Page 68
TROUBLESHOOTING, Troubleshooting
![]() |
View all Yamaha YSP-2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Problem Cause Remedy No sound. Incorrect input or output cable connections. Connect the cable properly. No appropriate input source has been selected. Select an appropriate input source with the input selector keys. The volume is turned down. Turn up the volume. The sound is muted. Press the MUTE ( ) or VOL (+/-) key to resume audio output and adjust the volume level. There is input signal cannot be played back by this unit. Play a source whose signals can be reproduced by this unit. Change the system settings of the source device. "HDMI AUDIO OUT" is set to "TV". Set to "AMP". "HDMI CONTROL" is set to "OFF". When connecting ARC (Audio Return Channel) supported TV and this unit using an HDMI cable only, set "HDMI CONTROL" to "ON". To use this unit with "HDMI CONTROL" set to "OFF", connect the TV's audio output jack to this unit's TV (optical) jack via the optical cable. Sound from an HDMI control-enabled TV is set for output from the TV's built-in speakers. Use the TV's HDMI settings to set audio output to any option other than the TV's built-in speakers. No sound or too small sound from The output level of the channel is muted. a specific channel. The beam setting is inappropriate. Raise the output level of the channel. Adjust the beam setting. The source is played in stereo playback mode. Switch to surround playback mode. Some audio output methods do not output sound beams for certain channels. Switch the sound beam output method. Surround sound effects are insubstantial. When connecting this unit with playback device and TV digitally, the output Refer to the manual supplied with your device and check the setting. setting of the playback device and TV is not valid. The playback device is set for constant output from 2 channels (PCM, etc.). Change the playback device's audio output setting. The listening room is not a regular shape, or the unit or listening position is Relocate the unit or listening position. not at the center of the right and left wall of the listening room. There is no wall in the path of the sound beam. Place the sound reflection board in the path of the sound beam. When MY SUR. (My Surround) is selected, listening position is not in front of Listen in front of this unit. the unit. See page 26 39 39 39 80 59 59 25 - 45, 56 32 40 42 - - 12 73 43 TROUBLESHOOTING ➤ Troubleshooting En 68
![](/manual_guide/products/yamaha-ysp2500-owners-manual-f322195/68.png)