Zanussi ZCG63260XE User Manual - Page 21

A 2 1 2. Pull up the trim. 3. Remove the glass panels. To replace the glass panels, do the same steps in reverse. Before you lower the trim, attach the A trim part to the door. Refer to the image. TROUBLESHOOTING REPLACING THE LAMP WARNING! Risk of electric shock. The lamp can be hot. 1. Turn off the oven. Wait until the oven is cooled down. 2. Disconnect the oven from the mains. 3. Put a cloth on the bottom of the cavity. The back lamp The lamp glass cover is at the back of the cavity. 1. Turn the lamp glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the oven lamp with a suitable 300 °C heat-resistant oven lamp. Use the same oven lamp type. 4. Install the glass cover. WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Remedy You cannot activate the appliance. You cannot activate the appliance. The burners do not work. There is no spark when you try to activate the spark generator. The flame extinguishes immediately after ignition. The appliance is not connected to an electrical supply or it is connected incorrectly. The fuse is blown. There is no gas supply. Burner cap and crown are placed incorrectly. Thermocouple is not heated up sufficiently. Check if the appliance is correctly connected to the electrical supply. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Check the gas connection. Place the burner cap and crown correctly. After lightning the flame, keep the knob pushed for equal or less than 10 seconds. 21