Zanussi ZCG63260XE User Manual - Page 9

BURNER OVERVIEW H G F A. Burner cap A B. Burner crown C. Location peg D. Slots E. Thermocouple F. Ignition candle B G. Burner body H. Hole for the ignition candle C D E A. Burner cap A B. Burner crown C. Slots D. Thermocouple E. Ignition candle F. Burner body B G. Hole for the ignition candle G C D E F REPLACING BURNER PARTS 1. Put carefully the burner crown on the burner body. Let the crown fall freely onto the body. Do not use force. Make sure that the hole in the crown is above the ignition candle. Make sure that the location pegs are in the slots in the burner body. Make sure that you can move the crown a small distance from side to side. 2. Put the burner cap centrally on top of the crown. Make sure that the cap is correctly installed, with the enamel side up and you can move the cap from side to side and front to back. 3. Light the burner. If the burner does not ignite, adjust the crown and cap again. TURNING THE BURNER OFF To put the flame out, turn the knob to the off position . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. LID SAFETY DEVICE Lid has safety device, which cuts off the gas supply for the hob. Closing the lid activates the safety device. WARNING! Always use the knob for the hob to switch off a burner. Do not use the lid as a cut-off device. 9