ZyXEL EX3510-B0 User Guide - Page 79
Label, Description
View all ZyXEL EX3510-B0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Chapter 6 Broadband The following table describes the labels in this screen. Table 16 Network Setting > Broadband > Add/Edit New WAN Interface (Routing Mode) LABEL DESCRIPTION General Name Type Mode Encapsulation Click this switch to enable or disable the interface. When the switch goes to the right function is enabled. Otherwise, it is not. , the Specify a descriptive name for this connection. This field shows an Ethernet connection. Select Routing if your ISP give you one IP address only and you want multiple computers to share an Internet account. Select the method of encapsulation used by your ISP from the drop-down list box. This option is available only when you select Routing in the Mode field. The choices are PPPoE and IPoE. IPv4/IPv6 Mode Select IPv4 Only if you want the Zyxel Device to run IPv4 only. Select IPv4 IPv6 DualStack to allow the Zyxel Device to run IPv4 and IPv6 at the same time. Select IPv6 Only if you want the Zyxel Device to run IPv6 only. PPP Information (This is available only when you select Routing in the Mode field.) PPP User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain where domain identifies a service name, then enter both components exactly as given. PPP Password Enter the password associated with the user name above. Select password unmask to show your entered password in plain text. PPP Connection Select when to have the Zyxel Device establish the PPP connection. Trigger Auto Connect - select this to not let the connection time out. Idle Timeout On Demand - select this to automatically bring up the connection when the Zyxel Device receives packets destined for the Internet. This value specifies the time in minutes that elapses before the router automatically disconnects from the PPPoE server. PPPoE Passthrough This field is not available if you select Auto Connect in the PPP Connection Trigger field. This field is available when you select PPPoE encapsulation. In addition to the Zyxel Device's built-in PPPoE client, you can enable PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client software on their computers to connect to the ISP via the Zyxel Device. Each host can have a separate account and a public WAN IP address. PPPoE pass through is an alternative to NAT for application where NAT is not appropriate. VLAN 802.1p Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client software on their computers to connect to the ISP. Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right , the function is enabled. Otherwise, it is not. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. 802.1q Type the VLAN ID number (from 1 to 4094) for traffic through this connection. MTU MTU Enter the MTU (Maximum Transfer Unit) size for traffic through this connection. IP Address (This is available only when you select IPv4 Only or IPv4 IPv6 DualStack in the IPv4/IPv6 Mode field.) EX3510-B0 User's Guide 79