Home » ZyXEL Manuals » Networking » ZyXEL PLA-450 » Manual Viewer

ZyXEL PLA-450 User Guide - Page 163

Preamble Type, IEEE 802.11g Wireless LAN, Wireless Security Overview, Fragmentation Threshold, RTS/CTS

Get ZyXEL PLA-450 PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 163 highlights

Appendix D Wireless LANs If the Fragmentation Threshold value is smaller than the RTS/CTS value (see previously) you set then the RTS (Request To Send)/CTS (Clear to Send) handshake will never occur as data frames will be fragmented before they reach RTS/CTS size. Preamble Type Preamble is used to signal that data is coming to the receiver. Short and long refer to the length of the synchronization field in a packet. Short preamble increases performance as less time sending preamble means more time for sending data. All IEEE 802.11 compliant wireless adapters support long preamble, but not all support short preamble. Use long preamble if you are unsure what preamble mode other wireless devices on the network support, and to provide more reliable communications in busy wireless networks. Use short preamble if you are sure all wireless devices on the network support it, and to provide more efficient communications. Use the dynamic setting to automatically use short preamble when all wireless devices on the network support it, otherwise the PLA450 uses long preamble. " The wireless devices MUST use the same preamble mode in order to communicate. IEEE 802.11g Wireless LAN IEEE 802.11g is fully compatible with the IEEE 802.11b standard. This means an IEEE 802.11b adapter can interface directly with an IEEE 802.11g access point (and vice versa) at 11 Mbps or lower depending on range. IEEE 802.11g has several intermediate rate steps between the maximum and minimum data rates. The IEEE 802.11g data rate and modulation are as follows: Table 50 IEEE 802.11g DATA RATE (MBPS) MODULATION 1 DBPSK (Differential Binary Phase Shift Keyed) 2 DQPSK (Differential Quadrature Phase Shift Keying) 5.5 / 11 CCK (Complementary Code Keying) 6/9/12/18/24/36/48/54 OFDM (Orthogonal Frequency Division Multiplexing) Wireless Security Overview Wireless security is vital to your network to protect wireless communication between wireless clients, access points and the wired network. PLA450 User's Guide 163

Section	Page
PLA450 Series	1
User’s Guide	1
About This User's Guide	3
Document Conventions	4
Safety Warnings	6
Contents Overview	9
Table of Contents	11
List of Figures	15
List of Tables	19
Introduction	21
Getting to Know Your PLA450	23
1.1 Overview	23
1.1.1 Wireless LAN Application	23
1.1.2 HomePlug AV	23
1.2 Ways to Manage the PLA450	24
1.3 Good Habits for Managing the PLA450	24
1.4 LEDs	25
The WPS Button	27
2.1 Overview	27
2.2 Push Button Configuration	27
The ENCRYPT Button	29
3.1 ENCRYPT Button Overview	29
3.2 Set Up a HomePlug AV Network with ENCRYPT	29
3.3 Setting Up Multiple Networks	31
3.4 ENCRYPT Button Behavior	32
Introducing the Web Configurator	35
4.1 Web Configurator Overview	35
4.2 Accessing the Web Configurator	35
4.3 Resetting the PLA450	37
4.3.1 Procedure to Use the Reset Button	37
4.4 Navigating the Web Configurator	37
4.4.1 The Status Screen	37
4.4.2 Navigation Panel	40
4.4.3 Summary: Packet Statistics	41
4.4.4 Summary: Wireless Station Status	42
4.4.5 Summary: My HomePlug Network Status	42
Wireless Tutorial	47
5.1 Example Parameters	47
5.2 Configuring the PLA450	47
5.3 Configuring the Wireless Client	49
5.3.1 Connecting to a Wireless LAN	49
5.3.2 Creating and Using a Profile	52
Network	55
Wireless LAN	57
6.1 Wireless Network Overview	57
6.2 Wireless Security Overview	59
6.2.1 SSID	59
6.2.2 MAC Address Filter	59
6.2.3 User Authentication	59
6.2.4 Encryption	60
6.3 Roaming	61
6.3.1 Requirements for Roaming	62
6.4 Quality of Service	62
6.4.1 WMM QoS	63
6.5 WPS Overview	63
6.5.1 WPS Setup Using a PIN	64
6.5.2 How WPS Works	65
6.5.3 Limitations of WPS	67
6.6 General Wireless LAN Screen	68
6.6.1 No Security	69
6.6.2 WPA-PSK/WPA2-PSK	70
6.7 MAC Filter	71
6.8 Wireless LAN Advanced Screen	72
6.9 Quality of Service (QoS) Screen	74
6.9.1 Application Priority Configuration	76
6.10 WPS Screen	77
6.11 WPS Station Screen	78
LAN	81
7.1 LAN Overview	81
7.1.1 Factory LAN Defaults	81
7.1.2 IP Address	81
7.1.3 IP Address and Subnet Mask	82
7.2 LAN IP Screen	82
HomePlug AV	85
8.1 Overview	85
8.2 Privacy and Powerline Adapters	86
8.2.1 Setting Up a Private Powerline Network	87
8.2.2 Setting Up Multiple Powerline Networks.	87
8.3 Configuring Your HomePlug AV Devices	88
8.4 HomePlug AV QoS	91
8.4.1 QoS Based on IP or MAC Address	91
8.4.2 Mapping other QoS Priority Settings to HomePlug AV QoS	91
8.4.3 QoS Based on Traffic Type	92
Maintenance and Troubleshooting	95
System	97
9.1 System General Screen	97
9.2 Time Setting Screen	98
Logs	101
10.1 View Log	101
10.2 Log Settings	102
Tools	105
11.1 Firmware Upload Screen	105
11.2 Configuration Screen	107
11.2.1 Backup Configuration	107
11.2.2 Restore Configuration	107
11.2.3 Back to Factory Defaults	108
11.3 Restart Screen	109
Configuration Mode	111
Language	113
13.1 Selecting Language	113
Troubleshooting	115
14.1 Power, Hardware Connections, and LEDs	115
14.2 PLA450 Access and Login	116
14.3 Internet Access	117
14.4 Resetting the PLA450 to Its Factory Defaults	118
14.5 Wireless Troubleshooting	119
14.6 HomePlug AV Troubleshooting	119
14.7 ENCRYPT Button Problems	120
14.8 Advanced Features	121
Product Specifications and Wall- Mounting Instructions	123
Appendices and Index	127
Pop-up Windows, JavaScripts and Java Permissions	129
IP Addresses and Subnetting	135
Setting up Your Computer’s IP Address	143
15.0.1 Verifying Settings	158
Wireless LANs	159
Common Services	173
Legal Information	177
Customer Support	181

Match case Limit results 1 per page

Appendix D Wireless LANs

PLA450 User’s Guide

163

If the

Fragmentation Threshold

value is smaller than the

RTS/CTS

value (see previously)

you set then the RTS (Request To Send)/CTS (Clear to Send) handshake will never occur as

data frames will be fragmented before they reach

RTS/CTS

size.

Preamble Type

Preamble is used to signal that data is coming to the receiver. Short and long refer to the length

of the synchronization field in a packet.

Short preamble increases performance as less time sending preamble means more time for

sending data. All IEEE 802.11 compliant wireless adapters support long preamble, but not all

support short preamble.

Use long preamble if you are unsure what preamble mode other wireless devices on the

network support, and to provide more reliable communications in busy wireless networks.

Use short preamble if you are sure all wireless devices on the network support it, and to

provide more efficient communications.

Use the dynamic setting to automatically use short preamble when all wireless devices on the

network support it, otherwise the PLA450 uses long preamble.

The wireless devices MUST

use the same preamble mode in order to

communicate.

IEEE 802.11g Wireless LAN

IEEE 802.11g is fully compatible with the IEEE 802.11b standard. This means an IEEE

802.11b adapter can interface directly with an IEEE 802.11g access point (and vice versa) at

11 Mbps or lower depending on range. IEEE 802.11g has several intermediate rate steps

between the maximum and minimum data rates. The IEEE 802.11g data rate and modulation

are as follows:

Wireless Security Overview

Wireless security is vital to your network to protect wireless communication between wireless

clients, access points and the wired network.

Table 50

IEEE 802.11g

DATA RATE (MBPS)

MODULATION

DBPSK (Differential Binary Phase Shift Keyed)

DQPSK (Differential Quadrature Phase Shift Keying)

5.5 / 11

CCK (Complementary Code Keying)

6/9/12/18/24/36/48/54

OFDM (Orthogonal Frequency Division Multiplexing)