ZyXEL UAG50 User Guide - Page 113
RJ-45 Ethernet Port
View all ZyXEL UAG50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
UAG50 User's Guide Appendix A Signal Connection Arrangements RJ-45 Ethernet Port The UAG50 RJ-45 Ethernet port can connect to any networking devices that use a standard LAN interface, such as a Hub/Switch Hub or Router. Use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cable to connect the networking device to the RJ-45 Ethernet port. Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as prescribed. 10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cables. 100Mbps: Use EIA/TIA-568-100-Category 5 cable. Figure RJ-45 Connector and Cable Pins Note: To prevent loss of signal, make sure that the length of any twisted-pair connection does not exceed 100 meters. 113
UAG50 User’s Guide
113
Appendix A Signal Connection Arrangements
RJ-45 Ethernet Port
The UAG50 RJ-45 Ethernet port can connect to any networking devices that use a
standard LAN interface, such as a Hub/Switch Hub or Router. Use unshielded
twisted-pair (UTP) or shield twisted-pair (STP) cable to connect the networking
device to the RJ-45 Ethernet port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following
Ethernet cable, as prescribed.
10Mbps:
Use
EIA/TIA-568-100-Category
3,
4
or
5
cables.
100Mbps:
Use
EIA/TIA-568-100-Category 5 cable.
Figure RJ-45 Connector and Cable Pins
Note:
To prevent loss of signal, make sure that the length of any twisted-pair
connection does not
exceed 100 meters.