ZyXEL VMG4825 User Guide - Page 108

Chapter 7 Wireless connections in which it is involved. If you want a configured AP to act as an enrollee, you must reset it to its factory defaults. 7.9.8.4 Example WPS Network Setup This section shows how security settings are distributed in an example WPS setup. The following figure shows an example network. In step 1, both AP1 and Client 1 are unconfigured. When WPS is activated on both, they perform the handshake. In this example, AP1 is the registrar, and Client 1 is the enrollee. The registrar randomly generates the security information to set up the network, since it is unconfigured and has no existing information. Figure 45 WPS: Example Network Step 1 ENROLLEE REGISTRAR CLIENT 1 SECURITY INFO AP1 In step 2, you add another wireless client to the network. You know that Client 1 supports registrar mode, but it is better to use AP1 for the WPS handshake with the new client since you must connect to the access point anyway in order to use the network. In this case, AP1 must be the registrar, since it is configured (it already has security information for the network). AP1 supplies the existing security information to Client 2. Figure 46 WPS: Example Network Step 2 EXISTING CONNECTION REGISTRAR CLIENT 1 ENROLLEE SECURITY INFO AP1 CLIENT 2 In step 3, you add another access point (AP2) to your network. AP2 is out of range of AP1, so you cannot use AP1 for the WPS handshake with the new access point. However, you know that Client 2 supports the registrar function, so you use it to perform the WPS handshake instead. VMG4825-B10A User's Guide 108