ZyXEL VMG4825 User Guide - Page 144
The QoS Shaper Setup Screen
View all ZyXEL VMG4825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Chapter 10 Quality of Service (QoS) Table 47 Classification Setup: Add/Edit (continued) LABEL VLAN ID Tag DESCRIPTION If you select Remark, enter a VLAN ID number with which the VMG replaces the VLAN ID of the frames. If you select Remove, the VMG deletes the VLAN ID of the frames before forwarding them out. If you select Add, the VMG treat all matched traffic untagged and add a second VLAN ID. If you select Unchange, the VMG keep the VLAN ID in the packets. Step4: Class Routing Forward to Interface Select a WAN interface through which traffic of this class will be forwarded out. If you select Unchange, the VMG forward traffic of this class according to the default routing table. Step5: Outgoing Queue Selection To Queue Index Select a queue that applies to this class. OK Cancel You should have configured a queue in the Queue Setup screen already. Click OK to save your changes. Click Cancel to exit this screen without saving. 10.6 The QoS Shaper Setup Screen This screen shows that you can use the token bucket algorithm to allow a certain amount of large bursts while keeping a limit for processing outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup. The screen appears as shown. Figure 70 Network Setting > QoS > Shaper Setup The following table describes the labels in this screen. Table 48 Network Setting > QoS > Shaper Setup LABEL Add New Shaper # Status Outgoing Interface Rate Limit (kbps) Modify DESCRIPTION Click this to create a new entry. This is the index number of the entry. This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is active. A gray bulb signifies that this shaper is not active. This shows the name of the VMG's interface through which traffic in this shaper applies. This shows the average rate limit of traffic bursts for this shaper. Click the Edit icon to edit the shaper. Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one when you take this action. VMG4825-B10A User's Guide 144