ZyXEL WAP3205 v3 User Guide - Page 22
Connection Wizard - Access Point Mode, 3.4.1 WLAN Setup, WLAN Setup
View all ZyXEL WAP3205 v3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Chapter 3 Connection Wizard Figure 8 Wizard Setup - General> System Operation Mode The following table describes the labels in this screen. Table 3 Wizard Setup - General> System Operation Mode LABEL DESCRIPTION Access Point Select Access Point to allow wireless devices to communicate with a wired network. Universal Repeater Select Universal Repeater to transmit traffic between two wireless networks. Client Bridge Select Client Bridge to connect your WAP3205 v3 to an existing network via an access point. Apply Click Apply to save the changes to your WAP3205 v3. Reset Click Reset to reload the previous configuration of this screen. Note: After choosing an operating mode, the next screen will vary according to the mode you have selected. If you have selected an operating mode different than the current mode, your WAP3205 v3 will restart. 3.4 Connection Wizard - Access Point Mode The WAP3205 v3's system operation mode is set to access point mode by default. In this mode your WAP3205 v3 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. 3.4.1 WLAN Setup The following screen will open. Use this screen to configure the WAP3205 v3's wireless network settings. Figure 9 Connection Wizard - Access Point Mode> WLAN Setup WAP3205 v3 User's Guide 22