2011 Chevrolet Traverse Owner's Manual - Page 296
2011 Chevrolet Traverse Manual
Page 296 highlights
9-38 Driving and Operating There is a message on the rear vision camera screen that states "Check Surroundings for Safety." Adjusting the Brightness and Contrast of the Screen To adjust the brightness and contrast of the screen, press the MENU button while the rear vision camera image is on the display. Any adjustments made will only affect the rear vision camera screen. disabled to use the caution symbols. If URPA has been disabled and the symbols have been turned on, the Rear Parking Assist Symbols Unavailable error message may display. See Ultrasonic Parking Assist on page 9‑34. The symbols appear when an object has been detected by the URPA system. The symbol may cover the object when viewing the navigation screen. To turn the symbols on or off: 1. Make sure that URPA has not been disabled. 2. Shift into P (Park). 3. Press the MENU hard key to enter the configure menu options, then press the MENU hard key repeatedly until Display is selected or touch the Display screen button. 4. Select the Video screen button. When the Video screen button is highlighted the RVC system is on. The delay that is received after shifting out of R (Reverse) is approximately 10 seconds. The delay can be cancelled by performing one of the following: . ] (Brightness) : Touch the + (plus) or - (minus) screen buttons to increase or decrease the brightness of the screen. _ (Contrast) : Touch the + (plus) or - (minus) screen buttons to increase or decrease the contrast of the screen. Symbols The navigation system may have a feature that lets the driver view symbols on the navigation screen while using the rear vision camera. The Ultrasonic Rear Park Assist (URPA) system must not be Pressing a hard key on the navigation system. Shifting in to P (Park). Reach a vehicle speed of 5 mph (8 km/h). . .