2004 Chrysler Concorde Owner Manual - Page 11
2004 Chrysler Concorde Manual
Page 11 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 11 for dealer replacement of keys. Duplication of keys may be performed at an authorized dealer or by using the Customer Key Programming procedure. This procedure consists of programming a blank key to the vehicle electronics. A blank key is one which has never been programmed. NOTE: When having the Sentry Key System serviced, bring all vehicle keys to the dealer. Customer Key Programming You can program new keys to the system if you have two valid keys by doing the following: 1. Insert the first valid key into the ignition and turn the ignition On for at least 3 seconds but no longer than 15 seconds. Turn the ignition Off and remove the first key. 2. Insert the second valid key and switch the ignition On within 15 seconds. After ten seconds a chime will sound and the Theft Alarm Light will begin to flash. Turn the ignition Off and remove the second key. 3. Insert a blank Sentry Key into the ignition and switch the ignition On within 60 seconds. After 10 seconds a single chime will sound. The Theft Alarm Light will stop flashing, and turn On for 3 seconds; then turn Off. The new Sentry Key has been programmed. Repeat this process to program up to a total of 8 keys. 2 CAUTION! An unlocked car is an invitation to thieves. Always remove the key from the ignition, lock the doors, close the windows, and raise the top when leaving the vehicle unattended. General Information The Sentry Key system complies with FCC rules part 15 and with RS-210 of Industry Canada. Operation is subject to the following two conditions: 1. this device may not cause harmful interference