2004 Chrysler Concorde Owner Manual - Page 86
2004 Chrysler Concorde Manual
Page 86 highlights
86 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Continue to press and hold the Universal Transceiver button while you press and release the hand held transmitter button until the frequency signal has been learned. Release both buttons when TRAINED appears in the display. Operation Press the desired universal transceiver button. The display shows that the appropriate channel signal is being transmitted and the programmed device should operate. For convenience, the hand-held transmitter of the device may also be used at any time. Reprogramming a Single Universal Transceiver Button 1. Press and hold the desired universal transceiver button for about 20 seconds. 2. When TRAINING appears in the display, position the hand-held transmitter one to three inches away from the universal transceiver surface. 3. Press and hold the hand-held transmitter button. 4. When TRAINED appears in the display, the previous programming for the button has now been erased and a new device has been programmed to the button. This procedure will not affect any other programmed buttons. Security If you sell your vehicle, be sure to erase the frequencies. To erase all of the previously programmed frequencies, hold down buttons one and three until CLEARED CHANNELS appears in the display. NOTE: Individual channels can not be erased. You must erase all three channels. This device complies with part 15 of FCC rules and with RS-210 of Industry Canada. Operation is subject to the two following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference that may be received including interference that may cause undesired operation. NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.