2004 Chrysler Concorde Owner Manual - Page 78
2004 Chrysler Concorde Manual
Page 78 highlights
78 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: Step 2 does not have to be followed to program additional hand held transmitters. 3. Choose one of the three buttons to train. Place the hand held controller one to three inches from the universal transceiver while keeping its indicator light in view. NOTE: Some entry gates and garage door openers may require you to replace step 4 with the procedures listed under Canadian Programming. 5. The indicator light in the Universal Transceiver will begin to flash, first slowly and then rapidly. The rapid flashing indicates successful programming. If after 90 seconds the indicator light does not flash rapidly or goes out, return to step 1 and repeat the procedure. To train the other buttons, repeat steps 3 and 4. Be sure to keep your hand held transmitters in case you need to retrain the Universal Transceiver. If you do not successfully program the Universal Transceiver to learn the signal of your hand held transmitter, refer to the Rolling Code Paragraph, or call toll free for customer assistance at 1-800-355-3515, or on the internet at www.homelink.com. 4. Using both hands, press the hand held transmitter button and the desired universal transceiver button. Do not release the buttons until step 5 has been completed. "Rolling Code" Programming NOTE: If your hand held transmitter appears to program the Universal Transceiver, but your garage door or other device does not operate, and your device was