2013 Dodge Journey Owner Manual - Page 255

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 253 1. Cycle the ignition to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. Firmly press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. NOTE: You have 30 seconds in which to initiate the next 3. Simultaneously press and hold both the HomeLink® step after the LEARN button has been pressed. button you want to program and the hand-held trans6. Return to the vehicle and press the programmed mitter button. HomeLink® button twice (holding the button for 4. Continue to hold both buttons and observe the inditwo seconds each time). If the garage door opener/ cator light. The HomeLink® indicator will flash slowly device activates, programming is complete. and then rapidly after HomeLink® has received the frequency signal from the hand-held transmitter. Re- NOTE: If the garage door opener/device does not actilease both buttons after the indicator light changes vate, press the button a third time (for two seconds) to complete the training. from slow to rapid. 5. At the garage door opener motor (in the garage), To program the remaining two HomeLink® buttons, locate the "LEARN" or "TRAINING" button. This can repeat each step for each remaining button. DO NOT usually be found where the hanging antenna wire is erase the channels. attached to the garage door opener/device motor. 3