2013 Dodge Journey Owner Manual - Page 257

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 255 which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian To reprogram a channel that has been previously trained, law, some U.S. gate operators are designed to time-out in follow these steps: the same manner. 1. Cycle the ignition to the ON/RUN position. It may be helpful to unplug the device during the cycling 2. Press and hold the desired HomeLink® button until process to prevent possible overheating of the garage the indicator light begins to flash after 20 seconds. Do door or gate motor. not release the button. 1. Cycle the ignition to the ON/RUN position. 3. Without releasing the button proceed with "Program2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) ming A Non-Rolling Code" Step 2 and follow all away from the HomeLink® button you wish to program remaining steps. while keeping the HomeLink® indicator light in view. Canadian/Gate Operator Programming 3. Continue to press and hold the HomeLink® button, For programming transmitters in Canada/United States while you press and release ("cycle"), your hand-held that require the transmitter signals to "time-out" after transmitter every two seconds until HomeLink® has several seconds of transmission. successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when Canadian radio frequency laws require transmitter signals fully trained. to time-out (or quit) after several seconds of transmission - Reprogramming A Single HomeLink® Button 3