2013 Dodge Journey Owner Manual - Page 545

MAINTAINING YOUR VEHICLE 543 4. Install the wiper blade pivot pin into the wiper blade To prevent freeze-up of your windshield washer system holder at the end of the wiper arm, and firmly press in cold weather, select a solution or mixture that meets or exceeds the temperature range of your climate. This the wiper blade until it snaps into place. rating information can be found on most washer fluid 5. Lower the wiper blade and snap the pivot cap into containers. place. The fluid reservoir will hold nearly 1 gal (4 l) of washer Adding Washer Fluid fluid when the message "LoWASH" appears in the The windshield washer and the rear window washer instrument cluster. share the same fluid reservoir. The fluid reservoir is located in the engine compartment. Be sure to check the WARNING! fluid level in the reservoir at regular intervals. Fill the reservoir with windshield washer solvent (not radiator Commercially available windshield washer solvents antifreeze) and operate the system for a few seconds to are flammable. They could ignite and burn you. Care must be exercised when filling or working flush out the residual water. around the washer solution. When refilling the washer fluid reservoir, apply some washer fluid to a cloth or towel and wipe the wiper blades clean. This will help blade performance. 7