2015 Jeep Grand Cherokee Owner Manual - Page 249

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 247 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. Firmly push and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. 3 3. Push and hold the HomeLink® button you want to NOTE: You have 30 seconds in which to initiate the next program while you push and hold the hand-held step after the LEARN button has been pushed. transmitter button. 6. Return to the vehicle and push the programmed 4. Continue to hold both buttons and observe the indiHomeLink® button twice (holding the button for two cator light. The HomeLink® indicator will flash slowly seconds each time). If the garage door opener/device and then rapidly after HomeLink® has received the activates, programming is complete. frequency signal from the hand-held transmitter. ReNOTE: If the garage door opener/device does not actilease both buttons after the indicator light changes vate, push the button a third time (for two seconds) to from slow to rapid. complete the training. 5. At the garage door opener motor (in the garage), To program the remaining two HomeLink® buttons, locate the "LEARN" or "TRAINING" button. This can repeat each step for each remaining button. DO NOT usually be found where the hanging antenna wire is erase the channels. attached to the garage door opener/device motor.