2015 Jeep Grand Cherokee Owner Manual - Page 251

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 249 5. Push and hold the programmed HomeLink® button and observe the indicator light. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pushed. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. Reprogramming A Single HomeLink® Button (Non-Rolling Code) 3. Without releasing the button proceed with "Programming A Non-Rolling Code" step 2 and follow all remaining steps. Canadian/Gate Operator Programming For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after several seconds of transmission. 3 Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink® To reprogram a channel that has been previously trained, to pick up the signal during programming. Similar to this follow these steps: Canadian law, some U.S. gate operators are designed to time-out in the same manner. 1. Cycle the ignition to the ON/RUN position. It may be helpful to unplug the device during the cycling 2. Push and hold the desired HomeLink® button until process to prevent possible overheating of the garage the indicator light begins to flash after 20 seconds. Do door or gate motor. not release the button. 1. Cycle the ignition to the ON/RUN position.