2015 Jeep Grand Cherokee Owner Manual - Page 252

250 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 5. Push and hold the programmed HomeLink® button cm) away from the HomeLink® button you wish to and observe the indicator light. program while keeping the HomeLink® indicator • If the indicator light stays on constantly, programlight in view. ming is complete and the garage door/device should activate when the HomeLink® button is pushed. 3. Continue to push and hold the HomeLink® button, • To program the two remaining HomeLink® buttons, while you push and release ("cycle") your hand-held repeat each step for each remaining button. DO NOT transmitter every two seconds until HomeLink® has erase the channels. successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when If you unplugged the garage door opener/device for fully trained. programming, plug it back in at this time. 4. Watch for the HomeLink® indicator to change flash Reprogramming A Single HomeLink® Button rates. When it changes, it is programmed. It may take (Canadian/Gate Operator) up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. To reprogram a channel that has been previously trained, follow these steps: 1. Cycle the ignition to the ON/RUN position.