2015 Jeep Grand Cherokee Owner Manual - Page 624

622 MAINTAINING YOUR VEHICLE 5. Gently lower the tip of the wiper arm onto the glass. Installing The Rear Wiper Adding Washer Fluid This vehicle is equipped with a Driver Information Display (DID), the DID will indicate when the washer 1. Lift the rear wiper arm pivot cap away from the glass fluid level is low. When the sensor detects a low fluid to allow the rear wiper blade to be raised off of the level, the windshield will light on the vehicle graphic glass. outline and the "WASHER FLUID LOW" message will be NOTE: The rear wiper arm cannot be fully raised off the displayed. glass unless the wiper arm pivot cap is unsnapped first. The fluid reservoir for the windshield washers and the rear Attempting to fully raise the rear wiper arm without un- window washer is shared. The fluid reservoir is located in snapping the wiper arm pivot cap may damage the vehicle. the engine compartment, be sure to check the fluid level at 2. Lift the rear wiper arm fully off the glass. regular intervals. Fill the reservoir with windshield washer solvent only (not radiator antifreeze). When refilling the 3. Insert the wiper blade pivot pin into the opening on washer fluid reservoir, take some washer fluid and apply it the end of the wiper arm. Grab the bottom end of the to a cloth or towel and wipe clean the wiper blades, this wiper arm with one hand, and press the wiper blade will help blade performance. To prevent freeze-up of your flush with the wiper arm until it snaps into place. windshield washer system in cold weather, select a solu4. Lower the wiper blade onto the glass and snap the tion or mixture that meets or exceeds the temperature range of your climate. This rating information can be found wiper arm pivot cap back into place. on most washer fluid containers.