2007 Mazda MAZDA3 Owner's Manual - Page 181
2007 Mazda MAZDA3 Manual
Page 181 highlights
Mazda3_8V66-EA-06F_Edition2 Page180 Friday, May 26 2006 10:54 AM Black plate (180,1) Driving Your Mazda Switches and Controls NOTE l CAUTION l When the wiper lever is in the AUTO position and the ignition switch is in the ON position, the wipers may move automatically in the following cases: l The auto-wiper control may not operate when the rain sensor temperature is about _10 °C(14 °F) or lower, or about 85 °C(185 °F) or higher. If the windshield is coated with water repellent, the rain sensor may not be able to sense the amount of rainfall correctly and auto-wiper control may not operate properly. If dirt or foreign matter (e.g. ice or matter containing salt water) adheres to the windshield above the rain sensor or if the windshield is iced, it could cause the wipers to move automatically. However, if the wipers cannot remove this ice, dirt or foreign matter, the auto-wiper control will stop operation. In this case, pull the wiper lever to the 1 or 2 position for manual operation, or remove the ice, dirt or foreign matter by hand to restore the auto-wiper operation. l l l If the windshield above the rain sensor is touched. If the windshield above the rain sensor is wiped with a cloth. If the windshield is struck with a hand or other object. If the rain sensor is struck with a hand or other object from inside the vehicle. l l Keep hands and scrapers clear of the windshield when the ignition switch is in the ON position as fingers pinched or the wipers and wiper blades damaged when they activate automatically. If you are going to clean the windshield, be sure the wipers are turned off completely this is particularly important when clearing ice and snow - when it is particularly tempting to leave the engine running. qWindshield Washer Pull the lever toward you and hold it to spray washer fluid. OFF Washer 5-58 Form No.8V66-EA-06F