2007 Mazda MAZDA3 Owner's Manual - Page 301
2007 Mazda MAZDA3 Manual
Page 301 highlights
Mazda3_8V66-EA-06F_Edition2 Page300 Friday, May 26 2006 10:55 AM Black plate (300,1) Maintenance and Care Owner Maintenance 3. Move the shift lever through all ranges, then set it at P. Fluid cold scale B When the engine has not been running and the outside temperature is about 20°C (70°F), the fluid level should be close to, but not above, the bottom notch on the dipstick. WARNING Sudden Vehicle Movement: Shifting the shift lever without first depressing the brake pedal is dangerous. The vehicle could move suddenly and cause an accident. Make sure the brake pedal is applied before shifting the shift lever. 4. With the engine still idling, pull out the dipstick, wipe it clean, and put it back. 5. Pull it out again. The proper fluid level is marked on the dipstick as follows. CAUTION l Use the cold scale only as a reference. If outside temperature is lower than about 20°C (70°F), start the engine and inspect the fluid level after the engine reaches operating temperature. If the vehicle has been driven for an extended period at high speeds or in city traffic in hot weather, inspect the level only after stopping the engine and allowing the fluid to cool for 30 minutes. l l Full A Low Full B Fully insert the dipstick. When adding fluid, inspect with the dipstick to make sure it doesn't pass full. NOTE Fluid hot scale A When the vehicle has been driven and the fluid is at normal operating temperature, about 65°C (150°F), the level must be between Full and Low. Inspect the fluid on both sides of the dipstick in a well lit area for an accurate reading. 8-26 Form No.8V66-EA-06F