2007 Mazda MAZDA3 Owner's Manual - Page 319

Mazda3_8V66-EA-06F_Edition2 Page318 Friday, May 26 2006 10:56 AM Black plate (318,1) Maintenance and Care Owner Maintenance Replacing a fog light bulb í 1. Turn the screw counterclockwise and remove it and partially peel back the mudguard. NOTE l To replace the bulb, contact an Authorized Mazda Dealer. If the halogen bulb is accidentally touched, it should be cleaned with rubbing alcohol before being used. Use the protective cover and carton for the replacement bulb to dispose of the old bulb promptly and out of the reach of children. l l Front turn signal lights/Side-marker lights 2. Disconnect the electrical connector from the bulb by pressing the tab on the connector with your finger and pulling the connector downward. 3. Turn the socket and bulb assembly to remove it. Carefully remove the bulb from its socket in the reflector by gently pulling it straight backward out of the socket. Due to the complexity and difficulty of the procedure, the bulbs should be replaced by an Authorized Mazda Dealer. Side turn signal lights 1. Slide the unit as shown in the figure to remove it. 2. Detach the electrical connector from the unit by pulling it to the rear. 4. Install the new bulb in the reverse order of removal. 3. Install the new side turn signal unit in the reverse order of removal. 8-44 í Some models. Form No.8V66-EA-06F