2013 Nissan Murano Owner's Manual - Page 105

Overdrive off indicator light GUID-A88B5A9D-E1E7-4ADD-B5C6-FE6EBACFA9C0 The overdrive off indicator light illuminates when the overdrive off mode is selected. For additional information, see "Continuously Variable Transmission (CVT)" in the "5. Starting and driving" section of this manual. . . When the luggage cover is pulled out and hooked so that the roof storage area is separated from the trunk. When the selector lever is in a position other than the R (Reverse) position. ignition switch ON, it may indicate the electric soft top control unit is not functioning properly. Have your vehicle checked by a NISSAN dealer as soon as possible. For more details about the electric soft top operation, see "Soft top (CrossCabriolet models)" in the "3. Pre-driving checks and adjustments" section. Soft top indicator light (CrossCabriolet models) GUID-387DFA5A-917F-4E6B-8A1D-1A0AD860A8FA This light illuminates when the soft top is being operated or it is stopped before reaching a full open/close state. When the top is fully opened or closed, the light will turn off. The light blinks while the soft top is not fully opened or closed under the following conditions: . . When the vehicle is driven. When the selector lever is in the R (Reverse) position. Be sure to fully open or close the soft top when driving the vehicle. The soft top can be moved with the soft top operating switch only under all of the following conditions: ...When the vehicle is stopped. When the ignition switch is ON. When the trunk is closed. CAUTION Operate the soft top with the engine running to prevent a discharged battery. When the soft top is operating, if any of the above conditions are discontinued or any of the following conditions are met, the top will stop operating. . When the selector lever is in the R (Reverse) position. . When the vehicle moves at a speed of 3 MPH (5 km/h) or more. . When the battery voltage is extremely low. . When the temperature of the soft top system becomes extremely high. Release the operating switch, and push it again under the above conditions until the top is fully opened or closed. The soft top indicator light will turn off when the top operation is completely finished. If the soft top indicator light illuminates with the Turn signal/hazard indicator lights GUID-F77394DF-EFC3-4B65-ACF6-5E0E91264160 The light flashes when the turn signal switch lever or hazard switch is turned on. Vehicle Dynamic Control (VDC) off indicator light GUID-CE6E8B94-E3C1-4EDD-B5CC-1AA8B731382A The light comes on when the Vehicle Dynamic Control (VDC) off switch is pushed to OFF. This indicates that the VDC system is not operating. For additional information, see "Vehicle Dynamic Control (VDC) system" in the "5. Starting and driving" section of this manual. Instruments and controls 2-19