2013 Nissan Murano Owner's Manual - Page 366
2013 Nissan Murano Manual
Page 366 highlights
Accelerator GUID-CD19E66D-4772-4785-B00D-BC9BC6AC4E04 downshift - In D position - For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. High fluid temperature protection mode GUID-FE0DB0A0-F4AF-44F6-8609-E1599FEA814D This transmission has a high fluid temperature protection mode. If the fluid temperature becomes too high (for example, when climbing steep grades in high temperature with heavy loads, such as when towing a trailer), engine power and, under some conditions, vehicle speed will be decreased automatically to reduce the chance of transmission damage. Vehicle speed can be controlled with the accelerator pedal, but the engine and vehicle speed may be limited. switch in the OFF position and wait for 10 seconds. Then place the ignition switch back in the ON position. The vehicle should return to its normal operating condition. If it does not return to its normal operating condition, have a NISSAN dealer check the transmission and repair if necessary. WARNING When the high fluid temperature protection mode or fail-safe operation occurs, vehicle speed may be gradually reduced. The reduced speed may be lower than other traffic, which could increase the chance of a collision. Be especially careful when driving. If necessary, pull to the side of the road at a safe place and allow the transmission to return to normal operation, or have it repaired if necessary. SSD0692 Overdrive (O/D) OFF switch GUID-8A3D61C2-25AC-4088-A419-A1EAB3D4657F When the O/D OFF switch is pushed with the selector lever in the D (Drive) position, the indicator light in the instrument panel illuminates. Use the overdrive off mode when you need improved engine braking. To turn off the overdrive off mode, push the O/D OFF switch again. The indicator light will turn off. Each time the engine is started, or when the selector lever is shifted to any position other than the D (Drive) position, the overdrive off mode will be automatically turned off. Fail-safe GUID-CA9C7C97-9363-4621-960F-9DED536408A1 If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may illuminate to indicate the fail-safe mode is activated. (See "Malfunction Indicator Light (MIL)" in the "2. Instruments and controls" section.) This will occur even if all electrical circuits are functioning properly. In this case, place the ignition 5-18 Starting and driving