2013 Nissan Murano Owner's Manual - Page 379

BREAK-IN SCHEDULE GUID-1450B7AB-549F-4778-B02E-889FA0A180B6 accelerator pedal. Your vehicle will maintain the set speed. . To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed. . The vehicle may not maintain the set speed on winding or hilly roads. If this happens, drive without the cruise control. To cancel the preset speed, use one of the following methods: 1. Push the CANCEL switch. 2. Tap the brake pedal. 3. Turn the MAIN switch off. The CRUISE light will turn off. . If you depress the brake pedal while pushing the ACCEL/RES or COAST/SET switch and reset at the cruising speed, the cruise control will disengage. Turn the MAIN switch off once and then turn it on again. The cruise control will automatically cancel if the vehicle slows more than 8 MPH (13 km/h) below the set speed. If you move the selector lever to the N (Neutral) position, the cruise control will be canceled. To reset at a faster cruising speed, use one of the following methods: . Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch. . Push and hold the ACCEL/RES switch. When the vehicle attains the desired speed, release the switch. . Push, then quickly release the ACCEL/RES switch. Each time you do this, the set speed will increase by about 1 MPH (1.6 km/h). To reset at a slower cruising speed, use one of the following methods: . Lightly tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it. . Push and hold the COAST/SET switch. Release the switch when the vehicle slows down to the desired speed. . Push, then quickly release the COAST/SET switch. Each time you do this, the set speed will decrease by about 1 MPH (1.6 km/h). To resume the preset speed, push and release the ACCEL/RES switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h). CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance. . Avoid driving for long periods at constant speed, either fast or slow. Do not run the engine over 4,000 rpm. Do not accelerate at full throttle in any gear. Avoid quick starts. Avoid hard braking as much as possible. Do not tow a trailer for the first 500 miles (800 km). Your engine, axle or other parts could be damaged. ... . . Starting and driving 5-31