2013 Nissan Murano Owner's Manual - Page 49

Attaching rearGUID-D73A39BF-43C8-459F-9C24-47B7F579C407 center seat belt: Always be sure the rear center seat belt connector tongue and connector buckle are attached. Disconnect only when folding down the rear seat. To connect the buckle: 1. Pull out the connector tongue from the 1 . retractor base * 2. Pull out the seat belt tongue from the 2 . retractor base * 3. Pull the seat belt and secure the connector 3 . buckle until it clicks * The center seat belt connector tongue and buckle are indicated by the ! and ~ mark. The center seat belt connector tongue can be attached only into the rear center seat belt connector buckle. To fasten the seat belt, see "Fastening the seat belts" earlier in this section. seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured. . If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop. SSS0235 Storing rear seat belt buckles (Hardtop models) GUID-34BA1AAF-B284-4222-A05C-7E212FF3C674 Before folding down the seat, put the buckles in the storage of the seat cushion to avoid dropping it under the seat cushion. SEAT BELT EXTENDERS GUID-798C755D-7740-4606-AB38-FAC398986CFA If, because of body size or driving position, it is not possible to properly fit the lap-shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that can be purchased. The extender adds approximately 8 in (200 mm) of length and may be used for either the driver or front passenger seating position. See a NISSAN dealer for assistance with Safety - Seats, seat belts and supplemental restraint system WARNING . Do not unfasten the rear center seat belt connector except when folding down the rear seat. When attaching the rear center seat belt connector, be certain that the . 1-25