2013 Nissan Murano Owner's Manual - Page 152

indicator light will flash slowly and then rapidly after several seconds upon successful programming. DO NOT release until the HomeLink® indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. The rapid flashing indicates successful programming. Proceed with "Programming HomeLink®" step 3 to complete. Remember to plug the device back in when programming is completed. If the HomeLink® does not quickly learn the hand-held transmitter information: replace the hand-held transmitter batteries with new batteries. . position the hand-held transmitter with its battery area facing away from the HomeLink® surface. . press and hold both the HomeLink® and hand-held transmitter buttons without interruption. . position the hand-held transmitter 1-3 in (26-76 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or 1-800-355-3515. . PROGRAMMING TROUBLESHOOTING GUID-0B904713-E37A-46A3-9A90-63FADE14E79C CLEARING THE PROGRAMMED INFORMATION GUID-8C1871E3-C252-465F-A399-47B1EB58E018 The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see "Reprogramming a single HomeLink® button" later in this section. To clear all programming GUID-A8FB6BA7-7DB6-4CE5-B9B3-E2187D21C0EE OPERATING THE HomeLink® UNIVERSAL TRANSCEIVER GUID-19BE850B-BBDC-470B-9850-DE6B57FF6B98 The HomeLink® Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink® Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. For convenience, the hand-held transmitter of the device may also be used at any time. 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds. 2. Release both buttons. HomeLink® is now in the programming mode and can be programmed at any time beginning with "Programming HomeLink®" - Step 1. To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLink® button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with "Programming HomeLink®" - Step 1. For questions or comments, contact HomeLink® REPROGRAMMING A SINGLE HomeLink® BUTTON GUID-2BF52974-A0FA-4080-821F-2E188B5DC58B 2-66 Instruments and controls