2013 Nissan Murano Owner's Manual - Page 370

BSW SYSTEM OPERATION GUID-57C34072-19AD-4F92-8527-4EC338107115 The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind Spot Indicator light located inside the outside mirrors will illuminate. If the turn signal is then activated, the system chimes (twice). brightness of the ambient light. A chime sounds if the camera unit has already detected vehicles when the driver activates the turn signal. If a vehicle comes into the detection zone after the driver activates the turn signal, then only the Blind Spot Indicator light flashes and no chime sounds. (See "BSW driving situations" later in this section.) Turning on or off the BSW system GUID-C47C5086-5272-41CD-9A3F-A6BA43F0B737 The BSW system can be turned on or off using the setting menu on the center display. SSD1026 Detection zone GUID-EDF6517E-4B22-4DBC-B7D0-02DAE5036383 The camera unit can detect vehicles on either side of your vehicle when part of another vehicle is within the detection zone shown as illustrated. This detection zone typically starts from the outside mirror of your vehicle and extends approximately 10 ft (3 m) behind the rear bumper, and approximately 10 ft (3 m) sideways. NOTE: The Blind Spot Indicator light will illuminate for a few seconds when the ignition switch is placed in the ON position. The brightness of the Blind Spot Indicator lights is adjusted automatically depending on the SYSTEM ON: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 The BSW light (green) on the instrument panel will light up. SYSTEM OFF:GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 The BSW light (green) on the instrument panel will go out. 5-22 Starting and driving