1998 Oldsmobile 88 Owner's Manual - Page 136
1998 Oldsmobile 88 Manual
Page 136 highlights
RCL: Press this button briefly to recall the station being PUSHBUTTONS: The five numbered pushbuttonslet played or to display clock. To change what is the you return to your favorite stations. You can set up to normally shown on display (stationor time), press the 15 stations (fiveAM, five FM1 and five FM2).Just: the RCL button until you the display you want, then see 1. Turn the radio on. hold the RCL button until display flashes.If you the 2. Press AM-FM to select the band. press the button when the ignition isoff, the clock will show for a few seconds. 3. Tune in the desired station. Finding a Station AM-FM: Press this button to switch betweenM , FM1 A and FM2.The display shows your selection. TUNE: Press this knob lightlyso it extends. Turnit to choose radio stations. Push knob back intoits stored the position when you're not using it. SEEK: Press the up or down arrow go to the next to higher or lower station and stay there. sound will The mute while seeking. SCAN: Press this button and release to listen to it The stations for a few seconds. radio will go to a station, go stop for a few seconds, then on to the next station. Press the button againto stop scanning. The sound will mute while scanning, and SCAN will appear the on display. If you press SCAN more than two seconds, for SCAN the radio will change to P SCAN mode. P will appear onthe display. 4. Press TONE to select the equalization that best suits the typeof station selected. 5 . Press and holdone of the five numbered buttons. The sound will mute. When returns, releasethe it button. Whenever you press that numbered button, the station youset will return and the tone that you selected will also be automatically selected for that button. 6. Repeat the steps for each pushbutton. P SCAN: Press SCAN for more than two seconds, and P SCAN will appear the display. The radio will go to on on the first preset station stored your pushbuttons, stop for a few seconds, then go on to the next preset station. Press SCAN again to stop scanning. 3-9