2009 Saturn VUE Owner's Manual - Page 275

Service and Appearance Care 4. Wipe the cap and the top of the reservoir clean. 5. Unscrew the cap and wipe the dipstick with a clean rag. 6. Replace the cap and completely tighten it. 7. Remove the cap again and look at the fluid level on the dipstick. The fluid level should be within the area indicated on the dipstick when the engine is cold. 5-27 Windshield Washer Fluid What to Use When you need windshield or rear window washer fluid, be sure to read the manufacturer's instructions before use. If you will be operating your vehicle in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing. Notice: • When using concentrated washer fluid, follow the manufacturer's instructions for adding water. • Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage your washer fluid tank and other parts of the washer system. Also, water does not clean as well as washer fluid. What to Use To determine what kind of fluid to use, Recommended Fluids and Lubricants on page 6-13. Always use the proper fluid. Notice: Use of the incorrect fluid may damage the vehicle and the damages may not be covered by the vehicle's warranty. Always use the correct fluid listed in Recommended Fluids and Lubricants on page 6-13. Adding Windshield Washer Fluid • Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full. Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview on page 5-12 for reservoir location. • Do not use engine coolant (antifreeze) in your windshield washer. It can damage the vehicle's windshield washer system and paint.