2009 Saturn VUE Owner's Manual - Page 70
2009 Saturn VUE Manual
Page 70 highlights
2-6 Features and Controls least two seconds. The vehicle's doors lock. Pressing / again, after the vehicle has started, shuts the vehicle off. When the vehicle starts, the parking lamps turn on and remain on while the vehicle is running. 3. After entering the vehicle during a remote start, and the engine is still running, turn the key to the ON/RUN position to drive the vehicle. If the vehicle is left running it automatically shuts off after 10 minutes unless a time extension has been done. If it is the vehicle's first remote start since it was last driven, repeat these steps while the engine is still running to give a 10 minute time extension. Remote start can be extended one time. To manually shut off a remote start: If the vehicle has the remote start feature, the RKE transmitter functions have an increased range of operation. However, the range may be less while the vehicle is running. There are other conditions which can affect the performance of the transmitter, see Remote Keyless Entry (RKE) System on page 2-3 for additional information. • Aim the RKE transmitter at the vehicle and press / until the parking lamps turn off. • Turn on the hazard warning flashers. • Turn the ignition switch on and then off. The vehicle can be remote started two separate times between driving sequences. The engine runs for 10 minutes after each remote start. Or, the engine run time can be extended another 10 minutes within the first 10 minute remote start time frame, and before the engine stops. For example, if Q and then / are pressed again after the vehicle has been running for five minutes, 10 minutes are added, allowing the engine to run for 15 minutes. The additional 10 minutes are considered a second remote vehicle start. / (Remote Start): This button is located on the RKE transmitter if the vehicle has remote start. To start the vehicle: 1. Aim the transmitter at the vehicle. 2. Press and release Q, then immediately press and hold / until the turn signal lamps flash. If the vehicle's lamps cannot be seen, press and hold / for at