AIWA CX-NHMT75 Operating Instructions - Page 14

MUSIC SENSOR If there is a 4-second or longer blank between each track, a search for the beginning of the current or next track during playback can be done easily. Press f or g during playback referring to the playback side indicator (x or c) on the display. For example, when g is pressed while c is displayed, playback of the next track starts. Music sensor function may not be able to detect tracks under the following conditions: • Blanks of less than 4 seconds between tracks • Noisy blanks • Long passages of low-end sound • Low overall recording levels CONTINUOUS PLAY About cassette tapes • To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool. Side A Type II tape detection slot Tab for side A To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type II tapes, take care not to cover the Type II tape detection slot.) • 120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended. • Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism. After playback on one deck finishes, the tape in the other deck will start to play without interruption. 1 Insert tapes into deck 1 and deck 2. 2 Press TAPE/DECK1/2 to select the deck to be played back first. 3 Press REV MODE to select [. 4 Press d to start playback. Playback continues until s is pressed. 14 ENGLISH