Adaptec AHA-2742T User Manual - Page 55
Run the EISA Configuration Utility, Copy Configuration and Overlay Files, Select the Host Adapter
View all Adaptec AHA-2742T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
AHA-2740 Series User's Manual Run the EISA Configuration Utility Run the EISA Configuration utility as instructed by the EISA system vendor. Place the bootable EISA configuration diskette in an operative drive and reset the system to boot from this diskette. If you have the Configuration utility installed on your hard disk, reboot your system and run the utility from your hard disk. After booting with the host adapter installed, ignore any error that indicates that an unknown board has been detected in the system. Copy Configuration and Overlay Files The !adp7771.cfg configuration file and adp7770.ovl overlay file needed to configure your host adapter with your EISA system are located on the diskette that came with your host adapter. The EISA Configuration utility typically allows you to select among a number of options, including copying new configuration files. Select this option to copy the !adp7771.cfg and the adp7770.ovl files from the host adapter diskette to either the bootable EISA configuration diskette or to the directory on your hard disk where the EISA Configuration utility is located. If the Configuration utility does not provide such an option, use the DOS Copy command to copy these files. Select the Host Adapter Once the configuration and overlay files have been copied, choose the option in the EISA Configuration utility that allows you to configure the EISA slot in which the host adapter is installed. If necessary, scroll down the screen until you find a screen that lists the host adapter and its parameters and looks similar to Figure 3-1. 3-4 Adaptec AHA-2740 Series User's Manual Stock Number: 510381-00 / Rev. C (Page 3-4) Print Spec Number: 491709-00 Rev C Current Date: 9/1/93 ECN Date: 9/14/93