Alpine IVA W200 Owners Manual - Page 11

Getting Started Accessory List • Head unit 1 • Power cable 1 • Remote cable 1 • Mounting sleeve 1 • Bracket key 2 • Flush Head Screw (M5x8 6 • Screw (M5×8 8 • Remote control 1 • Battery (CR2025 1 • Face plate 1 • Owner's Manual 1 set RESET switch Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, after changing the car battery, etc. Turn off the unit power, press RESET with a ball-point pen or similar pointed object. button Ejects a disc. Disc indicator Lights when a disc is inserted into the unit. About the button descriptions used in this Owner's Manual • The buttons found on the face of the unit are expressed in bold (e.g. SOURCE/POWER). The buttons found on the touch-screen display are shown in bold within brackets, [ ] (e.g. [SOURCE]). • This Owner's Manual explains mainly the function of soft buttons, when a soft button and a unit button have the same function. Connectable to Remote Control Interface Box You can operate this unit from the vehicle's control unit when an Alpine Remote Control Interface Box (optional) is connected. For details, contact your Alpine dealer. Location of Controls / button Press to adjust the volume. Remote Sensor Point the supplied remote control transmitter towards the remote sensor within a range of 2 meters. MUTE/SAT button Turns the MUTE mode ON or OFF. Press this button for at least 2 seconds to recall a weather channel or traffic channel. Center indicator Lights when the unit is turned on. SOURCE/POWER button Turns the power on. Press and hold for at least 2 seconds to turn the power off. Recalls the source selection screen. Turning Power On or Off Some of this unit's functions cannot be performed while the vehicle is in motion. Be sure to stop your vehicle in a safe location and apply the parking brake, before attempting these operations. 1 Press SOURCE/POWER to turn on the unit. • The unit can be turned on by pressing any button on the unit except (eject). 2 Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit. • The IVA-W200 draws minimal current even when its power switch is turned off. If the switched power (ignition) lead of the IVA-W200 is connected directly to the positive (+) post of the vehicle's battery, the battery may be discharged. If this lead is unswitched, it must be disconnected from the battery post should the vehicle be left unused for an extended period of time. An SPST (Single-Pole, Single-Throw) switch (sold separately) can be added to simplify this procedure. Then, you can simply place it in the OFF position when you leave the vehicle. Turn the SPST switch back ON before using the IVA-W200. For connecting the SPST switch, refer to the "Connection Diagram of SPST Switch (Sold Separately)" (page 69). • Some operation of the unit cannot be performed while the vehicle is in motion. In this case, be sure to first stop your vehicle and apply the parking brake, then perform the operation. • The IVA-W200 is a precision device. With gentle handling, its unique capabilities can be enjoyed for a long time. • In low ambient temperature conditions, the display may be dark for a short period of time immediately after the power is turned on. Once the LCD has warmed up, the display returns to normal. 9-EN