Alpine IVA W200 Owners Manual - Page 49

If PL II MUSIC is selected, the center width can be adjusted with following operations. This function offers the optimum vocal position by adjusting the center channel position between the center speaker and the L/R speaker. (The adjustments established in "Adjusting the acoustic image (BI-PHANTOM)" (page 45) are ineffective while this function is activated.) Touch [ ] or [ ] of CENTER WIDTH CONT to adjust the level. The level can be adjusted between 0 to 7. When the level increases, the center channel position moves from the center speaker position to both sides. Touch [OFF] of CENTER WIDTH CONT to turn off the center width control. • This adjustment is effective when the setting of the center speaker is SMALL or LARGE in the speaker setup settings. • "REAR FILL" function: Depending on the input signals, the sound may only be output from the front speakers. In this case, the "REAR FILL" function can be used to output signals from the rear speakers as well. • Avoid stopping, pausing, switching the disc, cueing, fast-forwarding or switching the audio channel of this unit while making this adjustment. The setting is canceled if the Decode mode is switched. • This adjustment is ineffective when the speaker is set to CENTER OFF in "Setting the Speakers" (page 40). • This function only works with two-channel signals. This operation is ineffective when 5.1-channel DTS or Dolby Digital signals are input. • If the setting of REAR FILL is made when REAR MIX is ON, sound is unchanged in the rear fill setting because REAR MIX is given priority during 2 channel decoder other than linear PCM. • For linear PCM signals, the voice is output from the rear speaker regardless of the REAR FILL and REAR MIX setting. • Touching [RETURN] will return to the previous screen. Linear PCM Setting The output when playing discs recorded in linear PCM can be set to 2 or 3 channels. 1 Check that Defeat mode is off. 2 Touch [SETUP] on the main source screen. The SETUP selection screen appears. 3 Touch [i-Personalize]. The i-Personalize screen will appear. 4 Touch [ ] of A.PROCESSOR. The A.PROC list screen appears. 5 Touch [ ] or [ ] of PCM MODE to select 2 CH or 3 CH. 2CH: 2ch output (L/R) 3CH: 3ch output (L/R/CENTER) • This adjustment is ineffective when the speaker is set to CENTER OFF in "Setting the Speakers" (page 40). Navigation System (Optional) Switching the Navigation Screen (Optional) If an optional Alpine Navigation System is connected to the IVA-W200, the Navigation screen can be displayed on this unit. 1 Touch [SOURCE] on the main source screen. The source screen appears on the display. 2 Touch [NAV]. The Navigation screen is displayed. The operation is possible with the supplied navigation remote control. For navigation operation, refer to the Owner's Manual of the navigator. • While the Navigation selection mode is being selected in "Setting the VISUAL Soft Button" (page 35), the navigation mode will be directly activated. • If the Navigation mode menu is not displayed on the main menu screen, set NAV. IN to on by following "Setting the Navigation Mode" (page 34). • When the Navigation System is on, the visual navigation cuts in. • For operation, if a navigation system with touch panel operation is connected, refer to the Owner's Manual of the navigation system. 47-EN