Alpine IVA W200 Owners Manual - Page 37

Setting of the Rear Camera When the rear camera is connected, rear pictures are output on the screen. Setting item: CAMERA IN Setting contents: OFF / ON ON: Even if the shift lever is not set to reverse (R), the rear pictures are output by selecting the CAMERA source. OFF: The CAMERA source is not displayed on the VISUAL selection screen. • By shifting to reverse (R), the rear pictures are output. This function is effective when the reverse wire is properly connected. • To apply the setting, set to VISUAL "Setting the VISUAL Soft Button" (page 35). Setting of the External Monitor Output Set it to ON when you use the rear entertainment function (page 25). Setting items: MONITOR OUT Setting contents: OFF / ON ON: By setting the connected external monitor to ON, the remote control will be usable. OFF: Remote control operation is not possible. Setting the VISUAL Soft Button Setting item: VISUAL KEY Setting content: VISUAL / NAV. NAV.: Switches directly to the navigation screen by touching [VISUAL]. VISUAL: Recalls the VISUAL Select screen by touching [VISUAL]. Setting the Digital Output To connect an audio processor using the optical digital output, set to "ON" by the following procedure. Setting item: OPTICAL OUT Setting contents: OFF / ON • Afterwards, set ACC to OFF once, then turn it ON again. The setting of Digital Output is decided. Subwoofer On and Off Setting item: SUBWOOFER Setting contents: ON / OFF ON: Subwoofer output is on. OFF: Subwoofer output is off. DISPLAY Setup Display Setup Operation To display the Display mode screen: To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Keep pushing the foot brake and release the parking brake once then engage it again. 3 When the parking brake is engaged for the second time, release the foot brake. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the Display mode operation has been released. Engaging the parking brake can reactivate the Display mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of "To display the Display mode screen." Each time the ignition is turned OFF, perform the procedure of "To display the Display mode screen." The following steps 1 to 5 are common operations to each "Setting item" of DISPLAY Setup. Refer to each section for details. 1 Touch [SETUP] on the main source screen. The SETUP selection screen is displayed. 2 Touch [OTHER SETUP]. The OTHER SETUP screen appears. 3 Touch [ ] of DISPLAY SETUP. The DISPLAY setup screen appears. 4 Touch [ ], [ ] or [OFF], [ON], etc., of the desired item to change its setting. Setting items: DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO BACKGROUND / BASE COLOR / PULSETOUCH / SCREEN ALIGNMENT 5 Touch [RETURN] to return to the previous screen. Touch [CONTROL] to return to the main source screen that was displayed before the setup operation was started. • Immediately after changing the settings of Display Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed. 35-EN