Belkin KVM over IP User Manual - Page 41
Step 6, Serial Settings
UPC - 722868596104
View all Belkin KVM over IP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Remote Installation Step 6 Serial Settings If you have a serial device connected to the Switch, such as a power distribution unit (PDU), you must configure the serial (RS232) settings. To open the Serial-Settings page, click "Serial Settings" under "Administration" in the far-left menu (see Fig. 5). Fig. 5 Serial-Settings Page To configure your serial device: 1. Type in the name of the serial device. 2. Using the drop-down menus, select the correct baud rate, parity, and data- and stop-bit parameters for the device. 3. Check the "Show" box. This will make the serial device appear in the list of servers and devices that can be accessed through the quick-access toolbar. 38
38
Remote Installation
Step 6
Serial Settings
If you have a serial device connected to the Switch, such as a power distribution
unit (PDU), you must configure the serial (RS232) settings. To open the
Serial-Settings page, click “Serial Settings” under “Administration” in the
far-left menu (see Fig. 5).
Fig. 5 Serial-Settings Page
To configure your serial device:
1.
Type in the name of the serial device.
2.
Using the drop-down menus, select the correct baud rate, parity, and
data- and stop-bit parameters for the device.
3.
Check the “Show” box. This will make the serial device appear in the list
of servers and devices that can be accessed through the quick-access
toolbar.