Bernina Artista 630 User Guide - Page 147

Thread Breakage While Embroidering Embroidery Support 147 It is possible that the upper thread may run out or break while embroidering. In this case the embroidery computer stops automatically provided that the upper thread sensors is 98 activated. 98 Upper Thread Breaks • the embroidery computer stops automatically when the upper thread runs out or has broken • a display message appears on the screen • check upper and if necessary lower thread and rethread • touch «ESC» • to continue embroidering press the StartStop button Lower Thread Runs Out • the embroidery computer does not stop automatically when the lower thread runs out Embroidery Sequence Control for Thread Breakage • touch «Embroidery Sequence Control» • a special screen appears • in the left portion of the screen the motif appears in its original size • in the right portion of the screen the motif appears in its enlarged size • the embroidery sequence can be better controlled • the Information Area for operating the stitch width and stitch length knob is displayed • turn the knobs counter clockwise (or clockwise) to move the embroidery hoop backwards (or forwards) in the embroidery sequence • turn the stitch width knob slowly to move the hoop stitch by stitch • turn the stitch length knob to move the embroidery hoop in big steps (approx. 50 steps) • the number in the Information Area shows the stitch count of the embroidery sequence • go back stitch by stitch to a position several stitches before thread breakage occurred to resume stitching • to reactivate the basic setting touch the blue knob icon • touch «ESC» and the special screen will close Resuming Embroidery • press foot control or Start / Stop - button on head frame to resume stitching • Embroidery screen reappears again • complete motif 031196.50.04_0507_a630_EN