Brother International Innov-is NQ1700E Operation Manual - Page 28

Embroidering Preparation Note • Make sure that there is no gap between the embroidery unit and the machine, otherwise the embroidery pattern may not be embroidered correctly. Be sure to fully insert the connector into the connection port. • Do not push on the carriage when attaching the embroidery unit to the machine, otherwise damage to the embroidery unit may result. • Do not touch the connector in the embroidery unit connection slot. The connector could be damaged, and it may cause malfunctions. • Do not lift up on the embroidery carriage, and do not forcefully move it. It may cause malfunctions. Turn on the machine. d  A message appears in the screen. Note • If [Opening Screen] is set [ON] within the settings screen, touch screen for the following message to appear. Be sure that no objects or hands are near the e embroidery unit and press . Turn off the machine. c CAUTION • Always turn off the machine before removing the embroidery unit. It may cause malfunctions if removed when the machine is turned on. Hold the release button on the bottom left of the d embroidery unit, and slowly pull the embroidery unit to the left.  The carriage moves to its initial position.  The screen for selecting the embroidery pattern type is displayed. ■ Removing the embroidery unit Make sure that the machine is completely stopped and follow the instructions below. Remove the embroidery frame. a • For details on removing the embroidery frame, refer to "Removing the embroidery frame" on page 30. Press , and then press . b  The embroidery carriage moves into a position where it can be stored. 26