Brother International Innov-is NQ1700E Operation Manual - Page 30
Attaching iron-on stabilizers backing to the, fabric, Inserting the fabric
View all Brother International Innov-is NQ1700E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Embroidering Preparation ■ Attaching iron-on stabilizers (backing) to the fabric For best results in your embroidery projects, always use stabilizer material for embroidery. Press the iron-on stabilizer material to the wrong side a of the fabric. • Use a piece of stabilizer which is larger than the embroidery frame being used. 1 Fusible side of stabilizer 2 Fabric (wrong side) 3 Size of the embroidery frame c a b Memo • When embroidering small pieces of fabric that cannot be hooped on an embroidery frame, use stabilizer material as a base. After lightly ironing the fabric to the stabilizer material, hoop it in the embroidery frame. If stabilizer material cannot be ironed onto the fabric, attach it with a basting stitch. After completing the embroidery, remove the stabilizer material carefully. 1 Fabric 2 Stabilizer 3 Basting ■ Inserting the fabric CAUTION • If you use a frame that is too small, the presser foot may strike the frame during embroidering and cause injury or may damage your machine. Note • If the fabric is not securely held in the embroidery frame, the embroidery pattern will stitch out poorly. Insert the fabric on a level surface, and gently pull the fabric taut in the frame, being careful not to distort hooped fabric. Lift-up and loosen the frame adjustment screw and a remove the inner frame. 1 Frame adjustment screw 2 Inner frame Lay the fabric right side up on top of the outer frame. b Re-insert the inner frame making sure to align the inner frame's with the outer frame's . c ab • When embroidering on thin fabrics such as organdy or lawn, or on napped fabrics such as terry cloth or corduroy, use water soluble stabilizer (sold separately) for best results. The water soluble stabilizer material will dissolve completely in water, giving the project a more attractive finish. • In the case of thick terry cloth towels we recommend that you place a piece of water soluble stabilizer on the top surface of the towel. This will help to reduce the nap of the toweling and result in more attractive embroidery. • When using fabrics that cannot be ironed (such as terry cloth or fabrics that have loops which expand when ironed) or in places where ironing is difficult, position the stabilizer material under the fabric without fusing it, then position the fabric and stabilizer in the embroidery frame, or check with your authorized Brother dealer for the correct stabilizer to use. 1 Inner frame's 2 Outer frame's 3 Frame adjustment screw Slightly tighten the frame adjustment screw, and then c remove the slack in the fabric by gently pulling on the edges and corners. Do not loosen the screw. 28