Brother International Innov-is NQ1700E Operation Manual - Page 37

Repeat the same steps for embroidering the remaining h colors.  When the last color is embroidered, a message informing you the embroidering is finished will appear on the display. Press , and the display will return to the initial screen. Cut the excess thread jumps within the color. i ■ Changing the thread color display You can display the name of the thread colors or embroidery thread number. Memo • Colors on the screen may vary slightly from actual spool colors. • [Original], imported data remains the brand thread created with the software, is set as a default. Press a and use or to display the following settings screen. Embroidering ■ If the bobbin runs out of thread When the bobbin begins to run out of thread during embroidering, the machine will stop and the message below will appear. Press and follow the directions below to replace the bobbin. If very little embroidering remains, you can embroider approximately 10 final stitches without rethreading the machine by pressing . The machine will stop after embroidering approximately 10 stitches. 2 Press . a EMBROIDERY  After the thread is automatically cut, the carriage will move. Unlock the frame-securing lever and remove the b embroidery frame. • Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the frame. Use or of the menu to select [Name of b Color] or [#123] (thread number). • When [Name of Color] is selected, the name of the thread colors is displayed. Insert a wound bobbin into the machine. (Refer to c "Installing the bobbin" on page 19.) • When [#123] is selected, the embroidery thread number is displayed. Use or of the menu to select the thread brand. Attach the embroidery frame. d Press . e Press . c 35