Brother International KE-436C Inner Clamping Device Instruction Manual - Engli - Page 19
Notes To Sewing Operations
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4 4. NOTES TO SEWING OPERATIONS 4 4. NOTES TO SEWING OPERATIONS 4.5mm 0032Q 基準点 Reference point 4.5mm 1 4.5mm 1. Reverse stitching is possible within 4.5 mm left and right from the reference point. However, note that if a non-standard work clamp crank is being used, the reverse stitching area will become smaller. 上がる Lift 2 1 memo-15 を ON 布の厚み Thickness of material 2630Q 2. When the work clamp crank (1) reverses after sewing is completed, the work clamps are retracted so that they do not touch the needle. However, sometimes it is not necessary to retract the work clamps if the material is thin. In such cases, if memory switch memo-15 is set to on, the work clamps will not be retracted so that the cycle time can be shortened. However, if making this change to the setting, move the work clamp crank to the sewing end position (release the air and move the work clamp crank by hand) to check that the work clamps do not touch the needle. KE-435C,436C 16