Brother International LK3-B434E MKII Instruction Manual - English - Page 11
Installing the motor, INSTALLATION
View all Brother International LK3-B434E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3. INSTALLATION 3-2. Installing the motor q u 1 mm Install the motor u to the work table with the four ac- cessory bolts q, cushions w, cushion collars e, flat q washers r, spring washers t and nuts y. At that time, fix by setting bolts q a little to the right of oval hole on motor. NOTE: Tighten the nuts y so that the clearance between the table and the cushion collars e is approximately 1 mm. w e r t y Table e 3-3. Installing the motor pulley q w e Place the motor pulley q onto the shaft of the motor w so that the key groove is aligned, and then tighten the set screw e so that the center of the V groove in the motor pulley q is aligned as closely as possible with the center of the belt hole in the power table. 5 LK3-B434E Mark II
5
LK3-B434E Mark II
q
w
e
r
y
u
q
e
Table
1 mm
t
3-2. Installing the motor
Install the motor
u
to the work table with the four ac-
cessory bolts
q
, cushions
w
, cushion collars
e
, flat
washers
r
, spring washers
t
and nuts
y
.
At that time, fix by setting bolts
q
a little to the right
of oval hole on motor.
NOTE:
Tighten the nuts
y
so that the clearance between the table
and the cushion collars
e
is approximately 1 mm.
3-3. Installing the motor pulley
Place the motor pulley
q
onto the shaft of the motor
w
so that the key groove is aligned, and then tighten
the set screw
e
so that the center of the V groove in
the motor pulley
q
is aligned as closely as possible
with the center of the belt hole in the power table.
3. INSTALLATION
q
w
e