Brother International LK3-B434E MKII Instruction Manual - English - Page 58

13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES 13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES The functions of the switches on the operation panel q can be changed to carry out special functions. NOTE: After changing the memory switch settings, press the power switch to turn the power off and then back on again. 1. Turn on the power switch. 2. While pressing the TEST switch w, press the BOB- BIN. WIND switch e. * "00 - - " will appear in the display window r. 3. Press the DISPLAY SET switches t to set the two B430E Series q digits at the left of the display window r to the corresponding number (00 to 4F) of the function shown in the table below that you would like to y select. POWER RESET P PROGRAM NO. X-SCALE Y-SCALE P1 P2 P3 P4 4. When the BOBBIN. WIND switch e is pressed, the two spaces at the right in the display window will change from " - - " to "ON". w TEST SPEED COUNTER r * If you press the RESET switch y at this time, memory switches will be returned to their initial e settings (factory default settings). BOBBIN.WIND SELECT 5. Press the TEST switch w. t * The display will return to normal. s Memory switches 00 - 0F Switch memo-00 memo-01 memo-02 Motion when set to ON At the end of sewing, the feed plate will be returned to the sewing start point via mechanical home position. Work clamp will move to the sewing start point, and then will be lifted. Feed will move automatically to the next starting point at the same time as a user program is switched. (Normally it moves to the starting point after sewing starts.) Initial value Solenoid Pneumatic -- -- ON ON -- -- memo-03 When sewing using programs, the programs which have been set will be sewn in numerical order. (Cycle sewing mode is set.) -- -- The sewing speed will be fixed at the minimum speed for the maximum memo-04 pitch of the sewing data. (Set this to ON if you are concerned that vartations in pitch may cause changes in the sewing speed.) -- -- Increases the presser solenoid lifting force (Set to ON when using the memo-05 optional spring for extra-heavy material) *1 -- memo-06 Enlargement and reduction ratio settings for X and Y become the same. -- -- memo-07 The inner clamping device can be used with pneumatic specifications. -- *2 memo-08 Test feeding is carried out stitch by stitch when the foot switch is depressed. -- -- The sewing start point becomes the reference point for enlargements and memo-09 reductions. (The reference point for enlargements and reductions is -- -- normally the center of the sewing frame.) memo-0A memo-0b memo-0c - - Needle stops in up position during emergency stop. -- -- -- -- -- -- The bar tacking stitches (with a pitch of less than 1 mm) are also enlarged memo-0d and reduced. (Normally stitches with a pitch of less than 1 mm are not -- -- enlarged or reduced.) memo-0E Test feeding will be performed at the same speed as that for actual sewing. (This is used for checking feeding operation.) -- -- memo-0F After sewing is finished, the work clamp automatically opens and closes once (practice operation). -- -- *1 ON for solenoid/heavy material specifications, and "--" for solenoid/medium material specifications *2 ON when the inner clamping device is being used, and "--" at other times LK3-B434E Mark II 52