Brother International LK3-B434E MKII Instruction Manual - English - Page 28
Operating procedure, 5-2-1. Setting the program number, 5-2-2. Setting the X-scale and Y-scale
View all Brother International LK3-B434E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
5. OPERATION 5-2. Operating procedure Preparation Turn on the power switch. (The POWER indicator q will illuminate and the program number will flash in the display window !.4 ) Factory default Variable range Program No. 0 *1 100 - *2 X-scale (%) 100 20 - 200 Y-scale (%) 100 20 - 200 Speed (rpm) 2000 1,000 - 2,500 *1 For checking the origin points for X and Y feed *2 Custom-made program 5-2-1. Setting the program number 1 Press the SELECT switch y until the PROGRAM NO. indicator illuminates. P PROGRAM NO. X-SCALE y Y-SCALE SPEED COUNTER SELECT 2 Press the DISPLAY SET switches !2 until the desired program number is flashing in the display window. !2 3 Depress the foot switch to the second step. NOTE: For two-pedal foot switch, depress the work clamp switch to lower the work clamp, before depressing the start switch. * The display will stop flashing and illuminates steadily, and the feed mechanism will move to the sewing start position. 1st step 2nd step This completes the setting of the program number. 5-2-2. Setting the X-scale and Y-scale 1 Press the SELECT switch y until the X-scale or Y-scale indicator illuminates. P PROGRAM NO. X-SCALE y Y-SCALE SPEED COUNTER SELECT 2 Press the DISPLAY SET switches !2 until the desired scale setting is flashing in the display window. (The setting is displayed as a percentage.) !2 3 Depress the foot switch to the second step. NOTE: For two-pedal foot switch, depress the work clamp switch to lower the work clamp, before depressing the start switch. * The display will stop flashing and illuminates steadily, and the feed mechanism will move to the sewing start position. 1st step 2nd step This completes the setting of the X-scale or Y-scale. 5-2-3. Setting the sewing speed 1 Press the SELECT switch y until the SPEED indicator illuminates. P PROGRAM NO. X-SCALE y Y-SCALE SPEED COUNTER SELECT 2 Press the DISPLAY SET switches !2 until the desired speed setting is flashing in the display window. NOTE: * Be sure to check the sewing pattern (refer to page 25) after setting has been completed to make sure that the needle hole does not go out of the area circumscribed by the work clamp. * The needle racking width for backtack stitches (with stitch widths of 1 mm or less) is not enlarged or reduced. If this results in problems, set memo-0d to "ON". !2 LK3-B434E Mark II 22