Canon MF7280 imageCLASS MF7280 Network Guide - Page 40
Confirm the settings you specified, press [OK]., If you use a DNS server, press [DNS Server].
UPC - 013803056129
View all Canon MF7280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
NOTE • Only one of the DHCP, BOOTP, or RARP settings can be selected at any one time. • Even if you press [DHCP], [BOOTP], or [RARP], you should enter an IP address, subnet mask, and gateway address. If this information cannot be obtained from the DHCP, BOOTP, or RARP server, the settings entered in this step are used. • If the machine is restarted after DHCP, BOOTP, or RARP settings are complete, the TCP/IP Settings screen displays the IP address setting values obtained from the DHCP, BOOTP, or RARP server. (If the IP address, host name, and domain name have been previously set, these will be overwritten by the setting values obtained from DHCP, BOOTP, or RARP.) • It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings can be used. If you do not plan to use one of these settings, it is recommended that you turn them off. 3 7 Confirm the settings you specified ➞ press [OK]. The display returns to the TCP/IP Settings screen. 8 If you use a DNS server, press [DNS Server]. Using a TCP/IP Network Otherwise, skip to step 13. Protocol Settings 3-7